LUVTruck.com

phpBBV3 Message Board
It is currently Sat Jun 21, 2025 9:49 am

View unanswered posts | View active topics


Board index » Technical » Modified Trucks - Drivetrain

All times are UTC - 6 hours




Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
GOTTALUVIT
PostPosted: Wed May 11, 2005 3:39 pm 
Well Currie sent me back a e-mail asking for the pinion offset. So i was wondernig for those of you that have tubbed your luv what pinion offset you used. It appears to be center offset but i just wanna make sure.
Top
  
Reply with quote  
jeff foreman
 Post subject:
PostPosted: Wed May 11, 2005 9:45 pm 
Offline
Senior Member

Joined: Sun Mar 06, 2005 9:16 pm
Posts: 62
YOU NEED TO HAVE THE PINION IN THE CENTER OF THE TRUCK. ONCE YOU HAVE IT CENTERED YOU CAN MEASURE FROM THE PINION THE HOUSING ENDS. THEY SHOULD BE THE SAME, ALTHOUGH THE AXLES WILL NOT BE THE SAME LENGTH., BECAUSE THE PINION IS NOT IN THE CENTER OF THE HOUSING. CONFUSED YET? GO TO MOSSER WEB SITE AND LOOK AT THE DIAGRAM ON HOW TO MEASURE..ARE YOU CUTTING YOUR OWN HOUSING ? AND WELDING NEW ENDS OR WHAT??
Top
 Profile  
Reply with quote  
GOTTALUVIT
 Post subject:
PostPosted: Thu May 12, 2005 1:35 pm 
No, Currie enterprise is building the rearend, they just need to know what pinion offset it is. I'm also having them install the 4-link brackets.
Top
  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Technical » Modified Trucks - Drivetrain

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 12 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group