LUVTruck.com

I am trying to sand down my truck so I can get a paint job on it but it is being a pain because I cannot get the front and back bumpers off because of some screws. If anyone knows how to take these screws off which are round and are held in by a back screw that would be great. The back I think I can handle, but does anyone know where to get a front and rear bumper, gas cap, and new rear tail lights that look a little classy. I don't know how to insert pice but if you can give me your email or tell me how to post pics, that would be great. Thanks

Not sure what exactly they "screws" you are talking about they should just be held on by either a 17 or 18mm I can't remember right off hand.



Gas cap

http://cgi.ebay.com/ebaymotors/Gas-Cap- ... dZViewItem

Far as tail lights I would try either redluv

http://forums.luvtruck.com/viewtopic.php?t=12177

or 11sec78

http://forums.luvtruck.com/viewtopic.ph ... 9&start=40

_________________

Unbolt the brackets from the frame instead of trying to get the chrome bolts that hold the bumper to the bracket out. Three bolts per side on the front and it is off, pretty much the same thing on the back too.

_________________
95 Isuzu Trooper Daily Driver
86 Isuzu Trooper reliable backup
77 LUV 2wd stock beltway blaster (resting)
79 4x4 LUV project: 2.6L, 5spd, 31s (eventually)

MEPR: Man, my 4x4 makes all other LUVs look good

ah I see. I never tried taking the bumpers off the mounts, I have always unbolted them from the frame. Guess I knew a Luv trick and didn't even know it

I see how it may present a problem trying it the other way.

_________________

would a 1971 to a 76 gas cap fit on a 1980 chevy luv?

no, wrong size hole

_________________
My old but now gone Luv...

What about a "NOS STANT GAS CAP G-726"

Ebay Item number: 330065777451

http://cgi.ebay.com/ebaymotors/NOS-STAN ... dZViewItem

_________________