LUVTruck.com

I just scored a weber 28/36 carb. I had never heard of one before. Anyone ever used these? I know that people put 32/36's on Luvs, but I don't know how a 28/36 would run.

_________________
You went there in that?!?!

i've heard of them before.....the 28 should be a little more snappy off idle but the sacrifice is needing to use the second barrel a little sooner during hard acceleration. however you probably won't have the cold start problems that i have. i can't seem to set my choke properly, i have to pump the crap out of the accelerator before it will run in the morning

technichly speaking the 32/36 is a little bit too big for the luv's 1.8 which results in a slight hesitation when you goose the throttle. so having a smaller primary bore is a good thing.

before i got my 32/36 i was considering the 30/32 which is the same bore as the stock hitachi (correct me if i'm wrong).

i'd really appreciate an update on how well your carb runs when you get it installed.

_________________

Thanks.

I thought I was getting an adapter with it, but I didn't. So now I've got to find an adapter. Anyone have one they want to sell me? I assume a 32/36 adapter would work.

On a similar note, I have an intake that I've had for many years. I don't know where I got it, maybe off an Impulse. I thought it was stock, but I measured the primary and secondary holes. they are 32 mm and 35 mm respectively. Is that normal or do I have something unusual?

_________________
You went there in that?!?!