LUVTruck.com • View topic - fuel tank sender

View unanswered posts | View active topics

Board index » Technical » Stock Trucks

All times are UTC - 6 hours

fuel tank sender

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

off road LUVer

Post subject: fuel tank sender

Posted: Wed May 07, 2008 9:22 am

LUVTruck.com Guru

Joined: Mon Jan 29, 2007 7:58 pm
Posts: 193
Location: Deming N.M.

is the stock fuel level sender a regular 90 ohm GM, or is it something else? the reason im asking is because im looking at this fuel gauge for my project luv. thanks!

http://www.iequus.com/product_info.php? ... id=100_105

_________________
(PLATINUM STREET RODS)
Deming, NM

Top

WED

Post subject: Re: fuel tank sender

Posted: Thu May 08, 2008 5:17 am

Junior Member

Joined: Fri Feb 23, 2007 7:39 am
Posts: 10
Location: El Paso, TX

My '79 factory manual gives the following specs for the fuel sending unit

Full position: 14.9 to 19.1 ohms
Half full: 40.5 to 49.5 ohms
Empty position: 113.5 to 126.5 ohms

Top

Johnboy

Post subject: Re: fuel tank sender

Posted: Thu May 08, 2008 4:15 pm

LUVTruck.com Guru

Joined: Tue Jan 10, 2006 6:51 pm
Posts: 150
Location: Raeford, NC

If you are going to use a after market gm gauge, you can get an after market gm fuel sending unit from JC Whitney Co. You will have to cut the unit to fit the gas tank, and do some minor drilling out of the mounting holes to get it to fit. The instructions will tell you what you have to do.

Top

Page 1 of 1

[ 3 posts ]

Board index » Technical » Stock Trucks

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 8 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum