LUVTruck.com

I recently did a disk brake swap on my '75 and I have a question. The drum brakes have two nuts that hold the brake hose to the frame. The disks have a nut on the brake side and a groove in the portion that goes through the frame bracket. I picked up a couple of pins, sort of hourglass shaped, that I slipped over the bracket and around the hose fitting groove. It seems to work but it looks a little weak. Is there a better standard part or pin that does the trick? I'd love a picture if you have one since this is hard to describe.

Khy in Austin, TX

Pert near on the road again

Like This?

_________________
1980 4x4 KBD40 ISUZU/Chev Luv
Factory Fitted c190 Diesel Engine, ARB BullBar, Ramsey Winch, Custom Tilt Tray,

Yup, that's it. Do you have any idea what those are called. I'm at the parts store tomorrow and I'd like to get a couple.

http://www.brakequip.com/fitpdf/misc.pdf

Brake Hose Retaining Clip

_________________
75 Luv, 350 V8, TH350, Camaro rearend. New 1975 Luv Step side. Stock for now.
Grandmaster of the "Shade Tree" way.. I can't see the yard for all the cars. Come on down and we will sit on the porch and watch the grass grow.

Nice. Thanks