LUVTruck.com

Well I moved to Washington but had a family emergency back here in Olahoma


OK there is a rattle coming from the back of my engine. Its not a knock its just a rattle. The engine was just rebuilt and all bolts were torqued to spec then pulled the engine and made sure the bolts were still torqued right. Yet however it still has the rattle. The only thing I can think of is somehow the clutch is rattling which is also brand new or possibly the flywheel is cracked. Any ideas would be helpful because this is the only thing keeping me from driving it now

_________________
When in doubt floor it. If you can't floor it then you've doubted yourself.

maybe your throw out bearing

It's also new :/

_________________
When in doubt floor it. If you can't floor it then you've doubted yourself.

pilot bearing possibly

Well its also new. The rattling stops once I let out on the clutch then starts rattling again once the RPMs level out.

_________________
When in doubt floor it. If you can't floor it then you've doubted yourself.

I have the same noise coming from my truck when the rpm's are leveled out right around 24-2700 rpm. Has been doing it for about 500 miles now and I still havent got it figured out so best of luck to you

Ok let me know if u figure it out and I'll let you know if I figure it out.

_________________
When in doubt floor it. If you can't floor it then you've doubted yourself.

sounds good....

i have seen a lot of starters go out and give a rattle

_________________
I will no longer do that thing with my tongue

Is your noise getting any better?

I haven't had the time to mess with it. I probably won't get around to it til this weekend.

_________________
When in doubt floor it. If you can't floor it then you've doubted yourself.