20 Years Late. We installed a Hooker header set with engine mounts years ago. Bellhousing bolts and spark plug access was always a pain. Dieter, our chasis man, noted that the engine setup was an inch to high. We pulled the engine and tranny and he built a new set of engine mounts and lowered the tranny mount 1 inch. He then cut off # 1 and 2's header tubes and made 12 different cuts and welds to allow plug access with a plug socket. Last night we installed the plugs in minutes! Now comes a question. Would this mod change the pinon/driveshaft angle? Last winter we installed Cal-Tracs and spent alot of time calculating angles. I'd hate to see these angles moused. Mr.T
|