LUVTruck.com

O.K., so i've been reading back like 14 pages thru it all to try and find some answers before i aksed.

I'm in the middle of baggin and BD my 76 luv. I can do the rear no prob, but the front has got me stumped as to the best route becuse i've read thru a few others builds....

first off, my plan is run RE6's and 6 lug. So here are my Questions:


1. So do i need to z the frame upfront to lay out?
I assume i need to atleast z the front since I'm going to BD and these trucks have the cab built in with the core support.


2. i was reading... viewtopic.php?f=7&t=9558
and are the drop spindles from the isuzu needed? they are for 6 lug right?

3. If they are needed(isuzu spindles), where is the cheapest place?

4. i read that i can just throw out the tortion bars, and it doesnt look like anyone adds any more support to the lowers? is that correct? they wont move or bend back?


thanks guys, thats all my brain can think of at the moment.

Gary

Did you read the write up from Bagged79?

http://forums.luvtruck.com/viewtopic.php?f=4&t=12675

yes, read threw it already but it doesnt answer my questions, and it kinda skips alot of his front end work.

Did you see this one? viewtopic.php?f=4&t=13796

_________________
If you think no one cares, try missing a couple of payments...



FIAA!

SFPP!

yep, read thru that one too. thats where i found out about z'n the frame. Guess I'll just have to figure it out as i go but i put my self on a timeline...lol

thanks man, I pm'd you another question.