LUVTruck.com • View topic - canver and caster

View unanswered posts | View active topics

Board index » Technical » Modified Trucks - Body and Chassis

All times are UTC - 6 hours

canver and caster

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

Rinox

Post subject: canver and caster

Posted: Thu May 15, 2003 4:46 pm

Hi!!!

somebody, tell me how is the caster an canver of chevy luv?..please!!

bye :lol:

Top

Blue Meanie

Post subject:

Posted: Thu May 15, 2003 7:25 pm

Addicted to LUV

Joined: Fri Aug 02, 2002 9:20 pm
Posts: 2013
Location: Copperas Cove, Texas

Caster and camber is set by adjusting the amount of shims at the upper A-arm mount point. There's no cam type adjuster for this. As for specs, i'll have to find out and get back to you.

_________________
Previous setup: 4.1 Buick V-6/TH 350
Current setup: 400 Small Block Chevy V-8/TH 350
9" ford rear end/short bed/blue
What do Water, Electricity and Humans have in common... They all travel the path of least resistance.

Top

Grimace

Post subject:

Posted: Sun May 18, 2003 8:16 am

OG Lifer

Joined: Wed Aug 14, 2002 8:38 am
Posts: 1005
Location: Guthrie, OK.

The shims look like body joint shims. I had the exact same shims in the fenders of my chevelle. They were painted metallic pea green from the factory. What a color

_________________
Hammer to fit, paint to match.
If it aint broke, don't fix it.
There's always room for duct tape and bailing wire.

WATCH YOUR PIEHOLE!!!!!!

Top

Page 1 of 1

[ 3 posts ]

Board index » Technical » Modified Trucks - Body and Chassis

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum