LUVTruck.com

I have posted a few times in the past about putting a big inch sbc in my 80 luv and have finally got the right engine at he builders and should be ready in aout two weeks. I know most everybody puts there's in a two wheel drive but I'm putting mine in a 4wheel drive for mudd racing and will be pushing somewhere around 630hp. Will be running a open dana 44 up front and a corp.12 in the rear with a 350 trans and a 208 transfercase, I've got a 3" body lift on it now does anybody think I'll have any problems with clearence form the trans or case? I just bought the Griffin radiator 19x22 that others say they run with no problem, any input on this would be welcome. I've alway's been a Luvtruck nut got several around the house and plenty Isuzu's also and the 80 Luv has the right look for a dirt drag truck and I'll be taken pic's. THANK'S SMOKEY

Sounds like a good setup. Look forward to the pics.

_________________
In life there is the "Way things should be" and then "There's the way they are".

2005 Silverado 3/4T Crew Cab
1981 Luv 2WD
1979 Luv 4x4 Currently going through Open Heart and Cosmetic surgery
1995 Roughneck JetBoat
1981 Luv parts trk

Trying to figure out how too post pics. Update already got a 9" installed on coilovers, ladder bars front and rear Toyota front axle on coilovers and would someone tell me how too put up pics.

Go to the General section there is a sticky on posting pic's.

_________________
1978 pro street step/side 455Buick, 4sp,4.11s, 31/18.5s