LUVTruck.com

does anyone know where to hook the engine hoist chains so i can lift the engine out.
never pulled out a 4cyl. thanks.

Opposite side around the intake and exhaust manifold ports. If the manifilds are removed then a piece of flat iron/angle iron with a hole drilled in it to bolt on the studs sticking out the block where the manifolds were bolted on will work.

_________________
In life there is the "Way things should be" and then "There's the way they are".

2005 Silverado 3/4T Crew Cab
1981 Luv 2WD
1979 Luv 4x4 Currently going through Open Heart and Cosmetic surgery
1995 Roughneck JetBoat
1981 Luv parts trk

i used some tie down straps and they worked just fine. i wrapped them like this.



kind of hard to see, but the straps are looped around the number one and two cyl exhaust manifold runner, and the same on the opposite side number three and four intake manifold.


it makes it a little hard to reinstall, but better than stripping a bold IMO

_________________

To the Oquirr hills for awesome thrills! Go-go 4wd, Activate!

thanks guys. engine is now out