LUVTruck.com • View topic

View unanswered posts | View active topics

Board index » Technical » Stock Trucks

All times are UTC - 6 hours

3rd member

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

theLUVman

Post subject: 3rd member

Posted: Sat Jun 21, 2003 11:07 am

LUVTruck.com Guru

Joined: Sun Jul 07, 2002 11:09 pm
Posts: 224
Location: k-ville ca

i just pulled my 3rd member off of my axle and noticed there was no gasket there im pretty sure there should be but im not an expert on this axle so if some one could tell me there is suppose to be a gasket here asap i would appreciate it. i have water in there so that is why i am taking it apart. oh ya and what type of gear oil should i use in the housing? last question what size bolt is the drain plug because i don't have that size and have to go and by one today. thanx. matt

_________________
1980 4x4 header stock motor lifted 4 1/2 in. in the rear and 3 1/2 in the front

Top

luv4me

Post subject:

Posted: Mon Jun 23, 2003 5:20 am

Addicted to LUV

Joined: Tue May 14, 2002 6:37 am
Posts: 1411
Location: Soddy Daisy

if you have no gasket you can use black RTV for a gasket. just a small bead will work and you won't have it all over the place. :wink:

_________________
03Cobra

Top

bighappy

Post subject:

Posted: Mon Jun 23, 2003 12:02 pm

Assimilated into LUVTruck.com

Joined: Mon Nov 18, 2002 8:43 am
Posts: 978
Location: Rockford IL

At the Toyota/Lexas shop where I work they never use gaskets on pans of any type. Always the black rtv.

Top

Page 1 of 1

[ 3 posts ]

Board index » Technical » Stock Trucks

All times are UTC - 6 hours

Who is online

Users browsing this forum: No registered users and 8 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum