LUVTruck.com

phpBBV3 Message Board
It is currently Fri Dec 15, 2017 2:11 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Jan 10, 2017 7:37 pm 
Offline
Junior Member

Joined: Thu Oct 06, 2016 4:09 pm
Posts: 6
Location: Portland, OR.
Hi all,

I tore down the stock g180 because of a blown head gasket. A bit of gasket between 3&4 sucked into the combustion chamber and it started knocking and lost all power.

Anyhoot, I've torn the whole damn thing apart, cleaned everything up, replaced all the bearings and have been putting it back together since September. But now I'm at a roadblock. The old cylinder head was toast, I pulled another that is in way better shape, but I forgot to nab the little dowel pin things that go between the CH and the block. I've looked hi and low on the internets and can"t get the proper info.

Is it a generic part that I can get anywhere or is it specific?

Thanks a bunch,
-Pony

_________________
Pony | 1980 Chevy Luv


Top
 Profile  
Reply with quote  
PostPosted: Sun Feb 19, 2017 12:09 am 
Offline
Junior Member

Joined: Thu Oct 06, 2016 4:09 pm
Posts: 6
Location: Portland, OR.
I made one by finding a bit of aluminum tube. cut it to length. dremeled a line through it. cleared all the burrs off and it seems to work.

_________________
Pony | 1980 Chevy Luv


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group