LUVTruck.com

phpBBV3 Message Board
It is currently Thu Jul 17, 2025 9:43 pm

View unanswered posts | View active topics


Board index » Newbie Section

All times are UTC - 6 hours




Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
badmike
 Post subject: spindle hub swap
PostPosted: Fri Mar 15, 2013 11:44 pm 
Offline
Newbie

Joined: Fri Mar 15, 2013 10:52 pm
Posts: 1
i am doing an 80 luv project street rod 510 hp 383 stroker 9 inch ford would like to keep front hubs the same pattern 5x4.5 bolt pattern for wheels does anyone know if there is a direct swap of hubs and rotor from 6 to 5 or do i just drill them and hope for the best. cheap !
Top
 Profile  
Reply with quote  
Luvrv8
 Post subject: Re: spindle hub swap
PostPosted: Sat Mar 16, 2013 9:42 am 
Offline
Addicted to LUV

Joined: Fri Jul 01, 2005 9:41 pm
Posts: 6289
Location: Camarillo, CA
Aerospace makes a set up for the LUV, it is spendy but nice. There was a guy here who was re drilling for five lug, try to use the search to find him.

_________________
Certified pilots, looking down on people since 1903.
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Newbie Section

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group