LUVTruck.com

Got a couple of different projects going

Luv #1

-2x3 frame, will be full caged front to back with 1 3/4 .120 wall tube
-14 bolt rear, dana 60 front
-350/th350/np205
-42" swampers
-Full hydro steering
-Deaver rear leaf springs, sprung under
-Front four link, 16 inch coilovers

















Luv #2

Picked this pile up for $400, drove it home. Needs a clutch BADLY. Slips so bad you can put the truck in gear, let off the clutch and it won't die or move . Cranked the torsion bars down on the front, ordered a clutch kit and some lowering blocks. Needs a lot of general maintanance, and some wiring help. Will slowly get it sanded down and throw some paint at it

badass..i like your style!

what he said
i cant wait to see that 4x4 done!

_________________
Luvless
1980 Mikado-Sold.

1993 Lexus SC400 my Daily
2004 Yamaha WR250F my new love in life
2016 Toyota Camry my girls ride

Nice welds!

_________________
1974 Mikado 4x4 50,000 orig. miles

Got a good part of the interior cage done, started the truss on the front axle. Motor is also mounted.

Lookin Sweet!!

_________________
Epic Fabrication.
KAOS

Thanks



This hot hooker strolled in Saturday evening.



Found this mummified mouse



Got the truss all cut out, and the lower links attached

I don't think I could drink enough for her to look good.

Nice fab job though!

SMOG! I bet I know what killed the mouse...

_________________
If you think no one cares, try missing a couple of payments...



FIAA!

SFPP!

, thanks





My theory is that merely had too much to drink the night before, and is simply dehydrated. What do you think got him?


More updates

I was grinding some brackets, I turn around, and this cupcake has appeared out of nowhere. Fawkin magic!



Got some more done on the truck

Teaser

Had to keep the forward tilt hood of course

Haven't done a lot with the truck. I started on the rear tube work, and started cutting the front fenders for the dove nose. Also decided to go spring over

Been helping this idiot put his Toyota together



Rear tube, not sure what behind this is going to look like





First cut on the fender

Been working on some other stuff for a while. Getting back to working on this thing, but decided to clean up the stall first. Rolled it outside for it's first breath of fresh air in a while. Front suspension is at full compression, rear is about two inches away

Started mounting the fuel cell. Radiator is also going to end up back here somewhere



Start of the fuel cell straps, will have these finished and on tomorrow night after work.

Cell got strapped

man that thing is looking good!
come up with any ideas for the rear end once its finished?


are the front fenders narrowed?

_________________
Luvless
1980 Mikado-Sold.

1993 Lexus SC400 my Daily
2004 Yamaha WR250F my new love in life
2016 Toyota Camry my girls ride

Thanks, not really any idea yet, once I start hanging bedsides on it I'm sure I'll figure something out. The nose is in the process of being narrowed

Radiator is mounted. I'm going to shove a artec quart crate between it and the fuel cell, then a couple of batteries are going to be mounted right behind the cab.