LUVTruck.com

phpBBV3 Message Board
It is currently Wed Apr 24, 2024 2:22 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 76 posts ]  Go to page Previous  1, 2, 3, 4  Next
Author Message
 Post subject: Re: CT'S STEPSIDE
PostPosted: Wed Sep 10, 2008 10:05 am 
Offline
Addicted to LUV

Joined: Fri Jul 01, 2005 9:41 pm
Posts: 6289
Location: Camarillo, CA
WildLuvRacing1974 wrote:
Sounds sweet. I likey!!!


Dont tell me you are afraid of a hurricane.

Good luck on the truck and even better luck on the hurricane, be safe and I hope no one has any major problems with it. My parents live in South Flordia so I understand the waiting game.

_________________
Certified pilots, looking down on people since 1903.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Wed Sep 10, 2008 5:52 pm 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
not afraid just want to know if i need to get the old plywood and screws out.... i hate this last minute stuff.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Thu Sep 11, 2008 8:45 pm 
Offline
Addicted to LUV
User avatar

Joined: Mon Dec 04, 2006 6:56 am
Posts: 3123
Location: East Central Iowa
good luck at the track.

_________________
Life is a DRAG RACE!!!
I like my Luv WILD!!!

Sometimes too much to drink isn't enough!!
Kinky is using a feather. Perverted is using the whole chicken.
http://www.wildluvracing.com
Image


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Tue Oct 07, 2008 6:55 pm 
Offline
Addicted to LUV
User avatar

Joined: Sun Jan 22, 2006 1:11 am
Posts: 2803
Location: Baytown,Texas
Sweeeeeet! sounds good . lot's of progress .


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 14, 2008 6:05 am 
Offline
Addicted to LUV
User avatar

Joined: Sun Jan 22, 2006 1:11 am
Posts: 2803
Location: Baytown,Texas
Bump for an update .


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 14, 2008 6:18 am 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
here's an update...
thought i had an engine problem turned out to be ok, put the motor back together and now the freaking oil pan has a small leak in the rear seal :evil: :evil: i can't get it to stop dripping for shit!!!!! going to try one more time to get it to stop if it don't gonna put a diaper on it and i'm headed to the nasty ( navasota ) on sunday the 16th to feel out the new truck a little.hoprfully everything will go well and not to many problems sunday.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 14, 2008 3:47 pm 
Offline
Addicted to LUV
User avatar

Joined: Thu Apr 07, 2005 11:48 am
Posts: 2581
Location: Republic of Texas, 77836
Little River (Temple Academy) Raceway has free racing Saturday the 15th, Food too. Gate is $15
About a 2 hours farther away....
http://www.littleriverdragway.com/boards/index.php/topic,152.new.html#new

Just a heads up...

_________________
75 Luv, 350 V8, TH350, Camaro rearend. New 1975 Luv Step side. Stock for now.
Grandmaster of the "Shade Tree" way.. I can't see the yard for all the cars. Come on down and we will sit on the porch and watch the grass grow.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 14, 2008 3:48 pm 
Offline
Addicted to LUV
User avatar

Joined: Thu Apr 07, 2005 11:48 am
Posts: 2581
Location: Republic of Texas, 77836
I am glad to see Navasota open back up again.

_________________
75 Luv, 350 V8, TH350, Camaro rearend. New 1975 Luv Step side. Stock for now.
Grandmaster of the "Shade Tree" way.. I can't see the yard for all the cars. Come on down and we will sit on the porch and watch the grass grow.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 21, 2008 12:01 am 
Offline
Addicted to LUV
User avatar

Joined: Sun Jan 22, 2006 1:11 am
Posts: 2803
Location: Baytown,Texas
bump for an update and full report on the "nasty" trip.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Nov 21, 2008 5:34 am 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
nasty trip was great....tech'ed in.... getting ready...... i let a little black falcon or comet go ahead of me and the next thing i know he leaves out of shape....goes from the right lane too the left over the guard rail on the left side and threw the wood wall and rolled over 1 or 2 times. 8O it took them about 45 minutes to get it back together.
truck ran like shit! got to figure out the stock shifter and how to shift AGAIN!!!! i only got two passes in 1st one maybe half track..miss shift into NEUTRAL :oops: felt ok, second pass left it in drive and it sounded like a single speed trans and only ran a low 7 but throttle cable was pulling out of the adjuster housing. the oil leak started again it smoked at the end of the last run so i called it a day and watched the others run. there were three other luvs out there a few s-10s overall the nasty had a good turn out for sunday. we have pic's on our web site and i will try to post a link later.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Fri Dec 05, 2008 9:10 am 
Offline
lives at LUVTruck.com

Joined: Fri Dec 14, 2007 1:46 pm
Posts: 356
Location: HUNTSVILLE, ALABAMA
question on the radiator, did you flatten the bottom tabs, I have the same radiator and I made a mount the puts the radiator in front of the rame about 2 inches below frame level because it looked like the raditor fill cap would hit the hood when closed. and what kind of ;lower pulley did you use? I am using a 2 groove.

Thanks for the great build it looks great


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 08, 2008 5:25 am 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
i did not flaten the bottom tabs but mt tabs are the same height as the front support and i did not have anyproblem with the rad cap hitting the hood, there is more room under the hood than looks i know it fooled me.i'm using a two groove pulley but it is for a short water pump set up, my old long water pump set up would not work on this truck motor was to far forward this time.i will see if i have a picture and post it.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 08, 2008 7:18 am 
Offline
lives at LUVTruck.com

Joined: Fri Dec 14, 2007 1:46 pm
Posts: 356
Location: HUNTSVILLE, ALABAMA
Thanks, I am running a 2 grove and short water pump also.
Picture would be great.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Sun Dec 14, 2008 11:40 pm 
Offline
Addicted to LUV
User avatar

Joined: Sun Jan 22, 2006 1:11 am
Posts: 2803
Location: Baytown,Texas
bumping this for an update man .


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 15, 2008 5:07 am 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
lost a lobe on the cam number 7 exhaust, so i'm tearing it down to replace the cam...for now i'm just going to put my old hyd cam in till after the first of the year :evil:


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 15, 2008 12:18 pm 
Offline
Addicted to LUV

Joined: Mon Aug 28, 2006 11:54 pm
Posts: 6584
Location: Pelahatchie, MS
Roller!

_________________
If you think no one cares, try missing a couple of payments...



FIAA!

SFPP!


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 15, 2008 12:32 pm 
Offline
lives at LUVTruck.com

Joined: Fri Dec 14, 2007 1:46 pm
Posts: 356
Location: HUNTSVILLE, ALABAMA
replacement = UPGRADE! (works most of the time with my wife , you know if I HAVE to repalce it might as well an upgrade) a Roller cam is always nice


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 15, 2008 12:33 pm 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
maybe after the holidays....i have to buy OTHER people gifts :x-mas:


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Sun Dec 21, 2008 6:17 pm 
Offline
Addicted to LUV
User avatar

Joined: Thu Apr 07, 2005 11:48 am
Posts: 2581
Location: Republic of Texas, 77836
Remember to put a good word into Santa while you are at it.

_________________
75 Luv, 350 V8, TH350, Camaro rearend. New 1975 Luv Step side. Stock for now.
Grandmaster of the "Shade Tree" way.. I can't see the yard for all the cars. Come on down and we will sit on the porch and watch the grass grow.


Top
 Profile  
Reply with quote  
 Post subject: Re: CT'S STEPSIDE
PostPosted: Mon Dec 22, 2008 5:37 am 
Offline
LUVTruck.com Lifer
User avatar

Joined: Thu Jan 25, 2007 7:24 am
Posts: 727
Location: SPRING,TX
PapaG wrote:
Remember to put a good word into Santa while you are at it.


i did put in a good word with santa..... hopefully he/she/me will deliver the 2004 gto with 8575 miles on it this week :D


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 76 posts ]  Go to page Previous  1, 2, 3, 4  Next

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 48 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group