LUVTruck.com

Hey I just joined the forum. I have a 1981 luv and am having a little trouble bleeding the brakes. I had to replace the rear end so that is why i am bleeding brakes. Pedal goes to floor on the first try, it will pump up but if you let it set for few minuetes it will go to floor again when pedal is pushed. Any help with this problem would be nice.

Could be a bad wheel cylinder in the new rear end..... Could be a bad master cylinder.

_________________
OK, I'm over it. Where's the beer?

Are they adjusted correctly?

_________________
Certified pilots, looking down on people since 1903.

It sounds like a bad master cylinder.

_________________
Life is a DRAG RACE!!!
I like my Luv WILD!!!

Sometimes too much to drink isn't enough!!
Kinky is using a feather. Perverted is using the whole chicken.
http://www.wildluvracing.com

!!!!!

_________________
zyanug
75 luv stepside... Work in progress
76 fleetside 350hp 1968 327cu
"No replacement for displacement!"
___/__l____
[_@l__l__@_]***

Bad master cylinder. The brake fluid is leaking past the seals back into the fluid reservoir.

it has a new master cylinder, will make sure they are adjusted correctly today, also new wheel cylinders on both sides. New master did not come with new rubber seals on bottom of plastic resivor.